Cause analysis of slag hanging in sa573 gr.65 structural quality carbon steel cutting process

The company regularly holds sales elites to share experiences, to promote the rapid growth of colleagues, and achieve the company and employees. The company conducts employee skill training and related knowledge video learning from time to time. All these things is to improve the employees' skills and literacy, and reflects its own value. It has always been the pursuit of BBN steel to enhance the employee’s ability and keep up with the times.

sa573 gr.65 structural quality carbon steel, 30CrMnSiA steel plate is a kind of low alloy high strength steel with medium carbon, high strength and good weldability. After quenching and tempering, 30CrMnSiA steel has high strength, enough toughness and good hardenability. After quenching and tempering, 30CrMnSiA steel can be used as grinding wheel shaft, gear and sprocket. 30CrMnSiA steel has good processability, small deformation and good fatigue resistance. 30CrMnSiA steel is usually used for shaft, piston parts, etc. It is used for various special wear-resistant parts of automobiles and airplanes.

A514 gr.H quenched and tempered alloy steel sheet chemical composition (melting analysis)%
C: 0.12-0.21, Si: 0.20-0.35, Mn: 0.95-1.30, P max.: 0.035, S max.: 0.035, Cr: 0.40-0.65, Ni: 0.30-0.70, Mo: 0.20-0.30, V: 0.03-0.08, B: 0.001-0.005
The mechanical properties in thickness (mm)T≤65
Yield strength (≥Mpa): 690
Tensile strength (Mpa):760-895
Elongation in ≥,%: 18

When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.