Our company will set up a full-time service engineer for the project, who is responsible for the interface and coordination of technical support and after-sales service of the ASTM A573 structural carbon steel project. In response process of customer serv
Our company will set up a full-time service engineer for the project, who is responsible for the interface and coordination of technical support and after-sales service of the ASTM A573 structural carbon steel project. In response process of customer service center, in case of technical support and after-sales service demand, the user shall contact the full-time engineer of ASTM A573 structural carbon steel customer service center, and the technical personnel will give corresponding answers and on-site treatment according to the needs of users.
High-temperature boiler steel plates such as 15CrMoR plate, 12Cr1MoVR steel plate, ASME SA387 grade 22 steel, A387 Gr 91 boiler steel, ASME SA1017 Gr 23, SA1017 Gr 911, SA1017 Gr 122 steel, ASTM A573 structural carbon steel, must have features of:Sufficient high temperature durability and durable plasticity;Good high temperature tissue stability;Good high temperature oxidation resistance (heat resistance);Good hot and cold processing technology (mainly refers to cold bending deformation and weldability), etc.
The wear-resistant plate has the main advantages of high strength and hardness, good toughness, ASTM A573 structural carbon steel high tensile strength, good material wear-resistance, long service life and low cost. In order to verify the wear-resistant life of the high wear-resistant composite steel plate applied in the field, the comparative industrial test of ASTM A573 structural carbon steel wear-resistant with the ordinary carbon plate was carried out on the reclaimer of Jigang raw material plant, and the effect is good.
In 2016. Our company offer 1200 tons API 5L GR.B hot rolled coil to Bangladesh——100 tons for 3.9*625mm, and 1100 tons for 7*683mm. It is one tender project, we get the tender at the end of 2015, and arrange the production in 2016. They required the tolerance of thickness is +0.1/-0.2mm, and width tolerance is +/-0.5mm, which is a very high requirement for coil tolerance, but our mill handling this very well. and our Q/C department witness all of the process.
Leave A Comment