BBN employees work hard and work hard in their work. In life, colleagues care about each other, like a family, and accompany each other at important moments in life. BBN Steel organizes employees to carry out tourism activities every year, so that familie
BBN employees work hard and work hard in their work. In life, colleagues care about each other, like a family, and accompany each other at important moments in life. BBN Steel organizes employees to carry out tourism activities every year, so that families can be exposed to nature and relax physically and mentally. The good combination of working and rest can achieve the goal of hard work and happy life.
The yield strength of Q690D steel plate is 690 Mpa and the impact temperature is - 20℃. S420N material vs a573 gr.65 steel, Q690D steel plate has high strength, good plasticity and toughness, good weldability and good cold and hot performance. Q690D steel plate is mainly used to manufacture various large engineering structural components and construction machinery. Because of its high strength and good toughness, Q690D steel plate can reduce the self weight of components and meet the requirements of large-scale and lightweight engineering components and equipment under the condition of ensuring strength, stiffness and reliability.
Normalizing is to heat the steel parts to 30~80℃above the critical temperature for a period of time. Then the parts are taken out of the furnace and cooled in air. Since the cooling rate of normalizing is faster than that of annealing, the strength and hardness of normalized S420N material vs a573 gr.65 steel are higher than that of annealed S420N material vs a573 gr.65 steel, but the elimination of internal stress is not as good as annealing. The normalizing operation of S420N material vs a573 gr.65 steel is simple, the cost is low, the productivity is high, and it is widely used in actual production.
In 2016. Our company offer 1200 tons API 5L GR.B hot rolled coil to Bangladesh——100 tons for 3.9*625mm, and 1100 tons for 7*683mm. It is one tender project, we get the tender at the end of 2015, and arrange the production in 2016. They required the tolerance of thickness is +0.1/-0.2mm, and width tolerance is +/-0.5mm, which is a very high requirement for coil tolerance, but our mill handling this very well. and our Q/C department witness all of the process.
Leave A Comment