SA573 Grade 65 carbon steel plate equivalent in indian standard

The difference between SA573 Grade 65 carbon steel plate, hot rolled sheet and cold rolled sheet: hot rolled sheet has low hardness, easy processing and good ductility. The cold-rolled sheet has high hardness and relatively difficult processing, but it is not easy to deform and has high strength. The cold rolled sheet is mostly used in automobile manufacturing and electrical products. Therefore, the two have their own characteristics. According to these characteristics, it is more appropriate to choose the right rolled plate to maximize its effect and benefit.

The capital letter H in S355J0H and S355J2H stands for ""Hollow section"", which respectively represents the pipe of S355J0 and S355J2.The Executive Standards of S355J0 steel and S355J2 steel, SA573 Grade 65 carbon steel plate are both EN 10025-2, the difference is that they have different temperature requirements for impact energy: S355J0 - impact energy at 0 ℃ is required to be ≥ 27J. S355J2: impact energy at - 20 ℃ is required to be ≥ 27J.

Standing at a new historical starting point, we adapt to the requirements of supply side structural reform, adhere to the overall strategy of "innovation driven, quality leading, SA573 Grade 65 carbon steel plate quality improving and efficiency increasing, transformation and development", and constantly improve the development concept and development level with a forward-looking vision and grand vision. Now we have been ranked the SA573 Grade 65 carbon steel plate International leading steel materials supplier.

After extrusion, the SA573 Grade 65 carbon steel plate tube shall be removed for sizing. The sizing machine uses a cone-shaped bit to rotate into the steel embryo at high speed to drill holes to form steel pipes. The inner diameter of the steel pipe is determined by the outer diameter length of the drill bit of the sizing machine. After sizing, the steel pipe will enter the cooling tower and be cooled by water spray. After cooling, the steel pipe will be straightened. After straightening, the steel pipe is sent to the metal flaw detector (or hydraulic test) by the conveyor belt for internal flaw detection.