Myanmar's demand for steel standard ASTM A573/A573M steel products is likely to exceed 3 million tons in 2020 and 5 million tons by 2025, according to seaisi. However, Myanmar's producers are unable to meet domestic demand, so the country's
Myanmar's demand for steel standard ASTM A573/A573M steel products is likely to exceed 3 million tons in 2020 and 5 million tons by 2025, according to seaisi. However, Myanmar's producers are unable to meet domestic demand, so the country's
Myanmar's demand for steel standard ASTM A573/A573M steel products is likely to exceed 3 million tons in 2020 and 5 million tons by 2025, according to seaisi. However, Myanmar's producers are unable to meet domestic demand, so the country's steel products are more dependent on imports. In 2019, Myanmar imported more than 1.9 million tons of steel standard ASTM A573/A573M finished steel, including 57% of long products, 13% of uncoated hot-rolled and cold-rolled flat products, and 30% of coated steel. In order to reduce its dependence on imports, Myanmar plans to increase its steel production capacity by building and expanding steel mills.
steel standard ASTM A573/A573M, Wear-resistant steel plates are easy to overheat, so pay attention to heating temperature and holding time. It is recommended to heat up to 820 degrees for proper insulation. Tempering temperature: 320 degrees, sufficient time. Hardness: 45-48HRC. Good performance. Salt bath NaCl:BaCl=3:7 can be heated at a temperature of 820, time is 30 seconds/mm (mm refers to the effective thickness of the part), oil cooling. Tempering temperature is 280, air furnace time is 2 hours, and nitrate furnace time is 30 minutes.
Q420C steel belongs to low alloy high strength steel. Q420 is named as the steel with yield strength of 420MPa, C means the impact temperature is 0 ℃, and Q is the abbreviation of yield strength. Chemical composition of Q420C steel: C ≤ 0.20, Si ≤ 0.50, Mn ≤ 1.70, P ≤ 0.035, S ≤ 0.035, Nb ≤ 0.07, V ≤ 0.20, Ti ≤ 0.20, Cr ≤ 0.30, Ni ≤ 0.80, Cu ≤ 0.30, N ≤ 0.015, Mo ≤ 0.20. The mechanical properties of Q420C steel are: yield strength ≥ 340 Mpa, tensile strength 500-680 Mpa, elongation after fracture ≥ 18%, impact energy 34J. steel standard ASTM A573/A573M, Q420C steel has good mechanical properties and weldability, good cold and hot workability.
With the development of China's market economy, the company vigorously implements the strategy of industrialization, internationalization and diversification, promotes the group operation, intensive development and lean management, and through a rich series of products and project portfolio as well as a complete operation network, Build the company into a modern enterprise with scientific development concept, continuous innovation vitality, excellent corporate culture, strong sense of social responsibility and international first-class competitiveness.
Leave A Comment